1994 kx125 sprocket Question

[jjpoepoe]

Can i put a 11 tooth front sprocket and a 52 tooth rear sprocket on my 1994 kx125 to increase the low end??? any suggestions????

 

[IndyMX]

Does anyone even make an 11 tooth?

I'd think that it'd be just a bit too small.

 

[_JOE_]

That would make the bike very snappy. What's the stock gearing?

 

[Kawi4life]

This is your second post about getting more bottom end on you 125. I hate to tell you, but if you're craving bottom end that bad then you just have the wrong bike. 125cc 2-strokes are just meant to rip. I know when I went with low-end tuned pipes for my 2-stokes it was like you lost a full gear of top-end. I would say if Dynoport is still makes the woods pipes, that would be your best bet. Otherwise, you just have the wrong bike for bottom end power, they're meant to rip up top. :nod:

 

[jjpoepoe]

That would make the bike very snappy. What's the stock gearing?

i dont know what that means???

 

[RM85rider123]

i dont know what that means???

What is the stock number of teeth on your drive sprocket and your tire's sprocket

 

[jjpoepoe]

What is the stock number of teeth on your drive sprocket and your tire's sprocket

front is 13 and rear 49

 

[_JOE_]

Your bike would likely top out at about 40mph. Very quick through the gears though. It will not make the engine any more powerful in the low end, however. It will just let it get to the midrange quicker.