Welcome to DirtRider.Net
FREE FORUM MEMBERSHIP and NO ADVERTISEMENTS.
TURN-OFF THE ADS!

Power valve / resleeve issue

Joined
Aug 1, 2016
Messages
1
Likes
0
Points
1
#1
Hey all, new to the forum.

I just got my 96 cr250r resleeved to the stock 66.4 bore. When trying to install the power valve, it's tagging the outside edge of the sleeve and wouldn't be able to fully close. Since this is my first bike, I would like to get a suggestion on whether to grind down the valve to fit, grind the sleeve or if there is a better alternative that you might know of if you've experienced this before. Any help is greatly appreciated.
 
- a d v e r t i s e m e n t -

Don't buy ANYTHING until you check the Gear Finder! PARTS, TOOLS & GEAR.
Try It!