01 cr125 sprocket seals

Joined
Apr 18, 2007
Messages
7
Likes
0
#1
Hi gang! Gotta question for all you experts. I'm ready to put the drive sprocket on. I have a small O-ring, a seal, sprocket, large washer and bolt. What order do these go on? My service manual doesn't show this, but a microfiche site shows the O-ring, seal, sprocket and washer/bolt. Any info? Thanks!
 
Joined
Apr 18, 2007
Messages
7
Likes
0
#3
So I slide the o-ring all the way along the shaft as far as it will go, then the seal with my trusty socket, then sprocket, washer and bolt?
 
Joined
Apr 18, 2007
Messages
7
Likes
0
#6
Oh wait. In the box of old parts I found a bushing, and then figured out that the o-ring goes into a slot around the bushing and then through the centre of the seal which I put in place ahead of time. Then sprocket, washer and bolt. Thanks for the help. It got my clock ticking when I saw the word bushing!