tsnobaddays

Member
Feb 11, 2008
39
0
I removed my rear wheel completly off the bike. When I

installed back on the bike and started to snug down on the

rear axle nut it puts something in a bind and the rear wheel

won't turn as freely as it should.

Axle block marks lines up on both sides

It was fine before I took off

The chain guide isn't in the way of anything

The axle bolt is put in on the correct side

I have a manual and followed instructions step by step and

still no luck. Any suggestions.
 

tsnobaddays

Member
Feb 11, 2008
39
0
Nope the reason I took the wheel off was to replace the tire. I greased everything before installation. The bearings were fine before I removed the rear wheel.
 

tsnobaddays

Member
Feb 11, 2008
39
0
I figured it out I didn't have the brake caliper bracket in the slide rail properly. I was just trying to rush and overlooked it.
 
Top Bottom