cr carl

Member
Dec 11, 2005
26
0
hi the any one tell me about my cylinder i think it has a sleeve in it instead of nikasil i took the head of and inspected it.i noticed that the cylinder and piston was just to much slack also the piston skirt had a minor crack in it.basically what can be done about it because i heard sleeves were bad news(the base of the cylinder was a goldy grey colour and a magnet stuck to the cyl wall anyone??????????
 

cr carl

Member
Dec 11, 2005
26
0
i ts not just the piston and rings it the fact i got the cylinder bore measured and it is supposed to be 2.615.but it isnt it is 2.616 why would it be wider what can be done or does this not matter????
 

skipn8r

Member
Mar 10, 2004
145
0
I don't think we can advise without actually seeing what you have. But, if it were me, I'd buy a new cylinder, piston and rings. It'll cost around $400 (including gaskets, etc.) by the time you're done, but you'll have a fresh start and you won't be trying to figure out what someone else has done.
 

Top Bottom