- May 1, 2001
- 1,452
- 0
I'm still working on dialing in the jetting on my 01 250 and it seems to get better every time(hey, this jetting stuff aint so bad afterall ;) ) I just wanted to compare my settings with everyone elses to see where I stand. I have been running:
178 main(stock)
45 pilot(stock) w/ AS ~1 out
CEL needle in mid clip-position.
This setup runs very well, but I get a very occasional lean surge, but not NEAR what it used to be. The only time it surges is on decel(closed throttle).
I have the forks off to put new seals in them, and in my boredom and need to tinker with something I raised the needle one clip(as raising the needle from 2 from top to mid has benefited most in the past) and checked my reeds. Reeds are good, but I haven't ridden it yet with the revised needle setting. Does this sound off? I've determined to the best of my knowledge that there's no air leak as well. Zero spooge also. Thanks for your opinions :cool:
178 main(stock)
45 pilot(stock) w/ AS ~1 out
CEL needle in mid clip-position.
This setup runs very well, but I get a very occasional lean surge, but not NEAR what it used to be. The only time it surges is on decel(closed throttle).
I have the forks off to put new seals in them, and in my boredom and need to tinker with something I raised the needle one clip(as raising the needle from 2 from top to mid has benefited most in the past) and checked my reeds. Reeds are good, but I haven't ridden it yet with the revised needle setting. Does this sound off? I've determined to the best of my knowledge that there's no air leak as well. Zero spooge also. Thanks for your opinions :cool: