Hi all,
I was hoping that someone may be able to assist with another boring jetting question. Hopefully this one may be more challenging as it relates to a KDX200SR (or 'F' model as we refer to in Aust).
The carb on this bike is the Keihin PE28 and standard settings are:
Main Jet=122, Throttle Cutaway=6.0, Needle=N68K - not sure if this is a Kwaka or Keihin part no, Clip postition=3rd from top, Pilot jet=45
So far so good.........
The bike has the following bolt on mods:
Pro Circuit pipe and silencer, removed airbox lid, probably Boyesen reeds by the time I finish this. Oh and it also runs a Wiseco sleeve and piston (standard size).
Does anyone have initial jetting suggestions or experience with this carb or similar mods? Temperature is normally around 20 degrees C and altitude is usually around 1000 ft but regularly goes up to 6000.
Also, does anyone know whether the jets (pilot and main) from an FCR carb will fit?
Thanks.
I was hoping that someone may be able to assist with another boring jetting question. Hopefully this one may be more challenging as it relates to a KDX200SR (or 'F' model as we refer to in Aust).
The carb on this bike is the Keihin PE28 and standard settings are:
Main Jet=122, Throttle Cutaway=6.0, Needle=N68K - not sure if this is a Kwaka or Keihin part no, Clip postition=3rd from top, Pilot jet=45
So far so good.........
The bike has the following bolt on mods:
Pro Circuit pipe and silencer, removed airbox lid, probably Boyesen reeds by the time I finish this. Oh and it also runs a Wiseco sleeve and piston (standard size).
Does anyone have initial jetting suggestions or experience with this carb or similar mods? Temperature is normally around 20 degrees C and altitude is usually around 1000 ft but regularly goes up to 6000.
Also, does anyone know whether the jets (pilot and main) from an FCR carb will fit?
Thanks.