Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Air leak at cylinder base/case. Help!!!!
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="griffbones, post: 1195658, member: 72285"] If it only started leaking after the last rebuild, I would say the cylinder probably didn't get seated down over the guide sleaves (hollow dowels around the studs) properly. Pull the cylinder and replace the guide sleaves and install a new base gasket, and I will just bet that you will be go to go. It only takes the smallest of burrs to keep the cylinder from seating all of the way down over the guide sleaves. Eric recomends putting a littel grease on the sleaves before installing the cylinder too. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Air leak at cylinder base/case. Help!!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom