Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="xpwarrior, post: 79292, member: 21365"] Well the top end is back together and the valves work smooth. Wasn't too bad of a job to clean everything. Is there a trick to tightening the nut under the left hand cover? The nut is the only thing that holds that gear and the left drum valve in place and I couldn't find a good place to hold everything while tightening it. Now i'm just waiting on a new boot for the gov shaft so I can finish up. CC are you sure it's a good idea to crank the whole system around by that nut. That means the little governor lever has to overide the spring pressure and that seems like a lot of stress for it. :eek: Also found something else interesting while cleaning. The previous owner installed Boyeson reed and managed to put the cage in upsidedown. This put everything at a major offset and was choking off the flow. I may have more power than I know what to do with now.:cool: [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom