Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="xpwarrior, post: 79695, member: 21365"] Here is a pic of the governor lever that broke last week. It only ran about 2 minutes and just looks like it was made out of crappy metal or they overheated it when they drilled the hole. The metal was crystalized where the rod went through but looked normal near the edges. [URL=http://www.geocities.com/xpwarrior/][B]Broken lever pic[/B][/URL] CC the nut I was trying to tighten was the RH nut under the round plug. The valves have to be lined up then the nut tightened to hold the gear in place. I got it tight by running it up against the stop. That kept the gear and the center shaft lined up. Just wondered because I thought this looked like the best way to remove it but I still managed to break the last tooth off of the gear. This was most likely because the nut was EXTREMELY tight. At least it was just on the single gear instead of the center shaft. :) I do have a shop manual but thanks anyway. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom