Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Clutch Hub Nut
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="RM_guy, post: 661546, member: 20652"] I usually snug it up with my impact wrench. Just make sure that the sides of the washer are bent up to keep the nut from spinning. Interesting story...I was removing the clutch basket from a bike and I used a 3/8' ratchet to loosen it up. This was before I got an impact wrench and I was all set to hold the basket from spinning and the nut just spun off. I could have removed it with my fingers. It hadn't been removed since new so it was like that from the factory. I figured there would be all kinds of wear so I throughly inspected everything. I couldn't find any problems. The bottom line is as long as there is no axial play in the basket (in doesn't slide on the shaft at all) then your set. I still tighten up good to make sure everything seats good but as long as the washer has prevented the nut from spinning, it will stay snug. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Clutch Hub Nut
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom