Hey about 2 years ago I had my clutch done at Yamaha. I own a 2000 YZ125. They replaced my clutch and top end since I was in school and did not have time. Anyway I have racked up about maybe 15hrs on it since then. When I first got the bike back the clutch felt so much better. Anyway after about 10 minutes of driving it when I pulled on the clutch lever it would not fully disengage until I tapped the brakes. I took the bike back over to the shop and they redid the plates again but the mechanic said there could be a small break in time. Sometimes it still happens today and I'm about to go riding in 3 weeks. Have you all seen this or is it suppose to take time to seat the new plates? Remember when I press in on the clutch it will keep going until I hit the brakes and then it will disengage the clutch. (not stall the bike)
Thanks
Thanks
Last edited:
