Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Correct Procedure for Bent Rim....
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="JTT, post: 168785, member: 19620"] Describing the procedure in words is a little difficult, but basically you are going to tighten the spokes on the side of the displaced portion of the rim. Look closely at how the wheel is built. You will see how tightening the spokes on one side will pull the wheel to that side and visa versa. Word of warning....make changes in very small increments. 1/4 turn at a time, max. You will need to set up some way to measure the runout. A trueing stand is best, but most of us don't have that option. I've used the axle in a stand, or even on the bike holding a stationary pointer to pick up the runout. Give it a try, just take your time and think out each move. If you have any buddies in the bicycle world, they are often adept at wheel trueing, as it is a normal part of life for them. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Correct Procedure for Bent Rim....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom