Crank centering question/ 95 200 H1

argclh6670

Member
Jan 27, 2013
37
0
hey guys quick question for ya all. just completed assembling cases after new crank, bearings and seals. this is the first green bike lower end ive done so... in the pic below the crank journals are closer to one side case than the other. the crank moves freely by hand, non binding nor dragging. is this crank out of center? Or is this just what it is? I think i have seen other posts with pics that depict the (offset) also. But im not sure. I used the heat n freeze method same as i have in the past on other models and have never seen this big of difference between the journals and case sides.

http://i1183.photobucket.com/albums/x472/6670argclh6670/crankpic_zps902ca07c.jpg
 

EYY

Member
May 22, 2010
159
1
If it doesn't touch the case, it should be okay IMHO. I dot see how it could be all bolted together like that without binding if something wasn't quite right, so maybe it's just the way it is. It may even center itself (if it is off to one side) during operation.

I wouldn't be worried.
 
Top Bottom