Dave I've just read over the “Is this possible...or am I just dreaming? “ thread in the Performance/Mods Forum and I have some questions for you. . . . . . Typically when looking at a list of improvements for increasing bottom to mid performance one of the first modifications to the top end is to turn the head down on a lathe and bump the compression. Eric's response indicates the compression was lowered, why? . . . . . . . Eric also talks about cutting the squish clearance down to 1.25mm. I'm assuming this is less than the stock setting. What effect does this have on power delivery?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?