Foot pegs pins and mounts are flogged out on my 250, is there such a thing as a complete assembly? I need to cut the old mounts off the frame and replace the lot.
Yeh, but the tabs aren't parallel anymore so I'd have to weld them up and reshape.
The frame bracket is forged and I reckon after welding may be hard to redrill, also worried about fatigue.
Yeh, but the tabs aren't parallel anymore so I'd have to weld them up and reshape.
The frame bracket is forged and I reckon after welding may be hard to redrill, also worried about fatigue.
Don't worry about fatigue, most people are fit enough to drill a couple of holes and it shouldn't be a problem.
I'd weld, drill and reshape them, tabs and all. If concerned about fatigue just give them a good visual inspection, they should be fine. As they are made of steel you'd see a fatigue issue before the mounts decided to break off. All just my opinion.