yam 3

Member
May 19, 2000
248
0
I think my cylinder may be warped since I cannot keep base gaskets from leaking. This last one i coated with yama bond in hopes of holding it in to no avail. Stock gaskets, 02 yz250.

Can a good machine shop turn the base down on a lathe?
Is this a common problem?
How do most people fix this????

This is driving me NUTZZZZZZZZZ
 

bclapham

LIFETIME SPONSOR
Nov 5, 2001
4,340
0
if you turn the base down, you are likely to need to head mod also. it will also give it more low end with a trade of top. that said, cometic makes gaskets in 6 thicknesses so you can get around it that way. if i were you, i would send it to eric!
 
Top Bottom