UnklFungus
Member
- Jun 5, 2008
- 10
- 0
I have a 1980 Yamaha IT125. I need to get the cylinder bored and the head machined to accept an oversize piston as mine slaps and has worn the port edges to a bit of a taper.
Who do you recommend? I spoke with someone locally who's boys race and he told me to send them out and not get it done locally..
I'll also need a good source for an oversized piston, rings wrist pin and clips, as well as anything else I might need to do this right.
Also, I need an air filter, and a good source to rebuild the rear shock.
Who do you recommend? I spoke with someone locally who's boys race and he told me to send them out and not get it done locally..
I'll also need a good source for an oversized piston, rings wrist pin and clips, as well as anything else I might need to do this right.
Also, I need an air filter, and a good source to rebuild the rear shock.