I am not a small engine mechanic, but I am trying to put a 26mm mikuni carb on a KLX 110. A couple of questions:
1) The foam air filter that comes with the kit is mounted directly on the carb, and should be oiled prior to use. Is this correct?
2) Where do I connect the fuel line to the carb? There is no connection in the same place as the stock carb. The place where I think it goes has a smaller connection than the stock carb.
3) The petcock must be plugged. I open it and no fuel comes out with a tank full of gas. How do I clean this out or should I replace it?
Thanks in advance.
1) The foam air filter that comes with the kit is mounted directly on the carb, and should be oiled prior to use. Is this correct?
2) Where do I connect the fuel line to the carb? There is no connection in the same place as the stock carb. The place where I think it goes has a smaller connection than the stock carb.
3) The petcock must be plugged. I open it and no fuel comes out with a tank full of gas. How do I clean this out or should I replace it?
Thanks in advance.
