Joe Kovarik said:when you put in your new rings slide then untill you feel then slip into a slot,just go slow and you will feel it then oil them up with a rag,use the oil you mix your gas with. Then slid your cylinder down to your first ring and pinch in your rings and slide it the rest oe the way.Then torque your cylinder use the crisscrose methop a little at a time you don't need a torque wrench to do this just tighten them untill they are tight ,most inportant thing is to crisscrossing.you can do it!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?