Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Question for Eric on Cylinder Head Milling
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="carrollcw, post: 163880, member: 24722"] Eric, It has been brought to my attention that you are an expert on the effects of milling a cylinder head on my old 84 CR500. I had the head milled due to some compression was leaking from the head because there was an indentation on it letting some leak. Within a few hours of riding, I screwed up the rings. I've heard these bikes already run hot and that could have made it worse. Do you think that it could be the problem? If so, what do I do to fix it? Thanks. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Question for Eric on Cylinder Head Milling
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom