I just installed my scott's steering damper today and I had to remove my cross bar on my pro taper bars in order for it to fit. Is this going to be a problem. What do yall think.
Check out Scott's website. It will demonstrate the bend you need to place in the crossbar for the Scotts to work. The crossbar serves a purpose. To remove it, will result in a sacrifice.
yes that is a problem the cross bar gives the bar strength. As Dave said bend the bar.I just did this it's not that hard. Put one end of the bar in a vise and give it a slight bend then do the other so its bowed in the middle takes a little time but keep bending till it clears.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.