bblack-22

Member
May 10, 2007
40
0
I took off the engine of my RM 250 the other day and now I need the case split my clymer manual refers to a crankcase seperator tool. And also I would need a rotor remover. Do I need these tools or do they just make it easier. also if I do need the tools where is a good place to get them without paying full price?
 

just_a_rider

Member
Jul 25, 2006
394
1
The rotor tool for shure but I know what I would do to split the case, make sure all the bolts are out and lightly tap around the case with a rubber hammer.
 

Bunya

Member
Apr 26, 2007
147
0
Fleabay for the flywheel puller.

To split the cases, I modified a steering wheel type puller by bolting a couple of pieces of flat plate to it with holes drilled in the ends to match up with some tapped holes in the case. Simple yet effective. Clear as mud?

Marc -
 

Welcome to DRN

No trolls, no cliques, no spam & newb friendly. Do it.

Top Bottom