Sage - I made a pin tool by using a Crescent adjustable wrench (metric of course :) ). I drilled through the jaws and pressed in solid pins. Buy a cheap wrench and they are not such hard steel.
You can make the bleeder tool for the comp adjuster on a lathe. I made blocks for the shafts and bodies on the lathe too, if Race Tech ones weren't appropriate.
The piston bleeder I made out of an old 46mm piston, with a really thick washer/shim combo on the compression side and a light shim on the rebound, mounted on a T handle. You need a 50mm for the PDS, but hey, I'm sure you knew that.
The resevoir piston depth setter I made from rod with a file handle on it and a drill depth stop on the shaft.
As far as I know you have to buy the genuine tool for recharging the nitrogen - you could make one but it would be a PITA.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.