smatta4u

Member
Feb 11, 2002
27
0
I am trying to replace the rear wheel bearings on my '02 YZ250. How do I get them out? Do I need a puller to remove both sides? There is not much room in between because of the spacer for a puller to grab the bearing. I think both bearings are up against a shoulder so I can't push thru from the opposite side. Any help is greatly appreciated. Thanks.
 

COLEMANAPP

~SPONSOR~
Feb 19, 2002
304
0
You need to remove the brake side c-clip, then punch out that bearing from the opposite side, Then remove the sprocket side bearing by punching it out from the brake side.
 
Top Bottom