Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
1997 CR250 Idle problem
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Toothmech, post: 868548, member: 56605"] You don't have to split the cases. Just pull the flywheel, and stator plate. Drill a small 1/8" hole into the existing seal on opposite sides of the crank output shaft(don't go too far and damage the aluminum case). Then thread in screws(sheetmetal) that binds tightly in the holes you drilled. Grab the screws with pliers and yank, the seal should pop right out. Clean the sealing surface and tap the new one in with a rubber mallet/ deadblow hammer and a piece of PVC pipe that matches the outer diameter of the seal. Be sure not to hammer the seal too far in. Some bikes have a flange that the seal seats against, others don't, so I recommend measuring how far the seal was set into the case prior to removal and relplacing it to that depth. Reassmble and pat yourself on the back for fixing the problem. Hope this helps. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
1997 CR250 Idle problem
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom