Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Yamaha MX & Off-Road Dirt Bikes
2004 Husky wr 250
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Tugsy, post: 853958, member: 51756"] Got the light kit on the bike. Here was my procedure: 1. Remove front number plate and the 2 support brckets at lower triple clamp. 2. Remove tank. 3. Remove yellow short wire from the voltage reg to the spade connection under tank. 4. Route the wiring harness along top frame tube to the front headlight area. Front of harness will have 1 yellow spade connection to go to voltage regulator. 1 small yellow and blue connectors to go to headlamp. Yellow one goes to farthest left connector and blue one goes to farthest right connector. White clip with several terminals connects to speedo lights which are 3 little bulbs that connect into speedo cover. 5. Attach round blue connector in middle of harnness to under the tank terminal post where others are already attached. Connect yellow spade to stator connection from stator. This is to repace connection you removed in step 3. 6. I ran back light of harness thru air box attached to frame. I have not finished rear light yet. Speedo Connection. 1. Insert threaded end into hole by front brake caliber. it is there just look carefully. Thread in until you see it flush on backside of caliber area. 2. Connect wire to the speedo unit. There are 2. Spin wheel to see if unit is working. Magnet for unit should be installed on front disk from factory.Mine wasn't but I figured it out. 3. If it is working disconnect and route the speedo cable up just like the brake cable and zip ty together all the way up. 4. Loosen the bar clamps from under the top triple clamp. Lift up and insert speedo mount with rounded bolt holes facing down on top top trile clamp area and reinsert bar clamps. 5. Insert speedo unit into plastic holder and then attach to speedo mount. There should be 2 rubber o ring things that snap into speedo mount and then screw 2 small palstic screws with washers into under side of speedo mount. Connect 2 wires again and your done. Hope this helps. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Yamaha MX & Off-Road Dirt Bikes
2004 Husky wr 250
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom