Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
89 KDX200 Headlight. Help & win a cookie: PART II
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="reepicheep, post: 1364321, member: 104942"] You don't need to do the Y thing, just get as much of the wire through the hole as you can, then solder it on. Before attaching, put some heat shrink tubing higher up on the wire, so you can slide it over the joint when you are done, and heat it up so it clamps down. That'll provide some strain relief, and hopefully keep the soldered joint from cracking. I'd also try and put one big heat shrink tube over the whole mess, again to give it more strain relief. If you want it to be easier to work on, you could always solder on 5" leads on the bench (match the wire colors) then put crimp connectors on the other side. Not necessary, nd that gives you another joint that could fail, but if it's an awkward position that may be easier. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
89 KDX200 Headlight. Help & win a cookie: PART II
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom