Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
89 KDX200 Headlight. Help & win a cookie: PART II
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="DirtyRyan, post: 1365268, member: 109026"] 'm not real sure I follow about that last answer. Reepicheep had said earlier that: "for the tailight Brown is commonly running light 12v (allways on) the others just set a meter on continuity and leads between green/white and brown green white and white and white and brown you should get a beep from brown to green white and white to green white and nothing between brown and white meaning the green white is ground and white is brake." So, if I have this right....I would think that the factory red, would connect to the taillight brown. The Green/White would hook up to the existing factory Black/Yellow wire. Then the White would hook into one of the 2 brake light wires. Is that much right? I also get a tad confused about the second brake light switch wire. Am I correct in thinking that the second brake light switch wire should connect into a Y splice with the horn switch wire, and the both of those run into the yellow power source wire? Next item of question: The Voltage Regulator. If I understand right, there was no VR on 89 KDX200s. That being the case, there's no real "set place" to mount this thing into the system. I looked around the frame for a bit yesterday trying to figure out where to put it, but I can't seem to think of a satisfactory place to mount it to. As it stands, it seems like I would have to just run a zip-tie through the hole in the middle and affix it to part of the frame, kind of in the area near the spark plug. Any idea's on where you might mount this little bugger? I can't help but think that if I did what I mentioned above that the vibration of the VR against the frame would A) sound like hell, and B) possibly end up damaging the VR. I just can't seem to think of a good place to place the VR. Any suggestions would help. I know I had some other questions, but that's all that comes to mind now. I'm gonna start in wiring up that second diode into the red wire now. I'll check back after a bit. Hope ya'll are doin well! Thanks for all the help! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
89 KDX200 Headlight. Help & win a cookie: PART II
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom