Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
97 CR80 Rear Hub Worn - Suggestions?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="rikhek, post: 846856, member: 56803"] Spoke to a machinist today and he said it would be difficult and costly to weld and machine back to spec. He suggested trying some high strength lock-tite between the outer race and the hub. Said I should heat it up a bit with a torch and then put the lock-tite on as the heat helps the lock-tite set up. I have just enough play around the race to where the lock-tite would "get in." Any thoughts? As a last resort I thought I might just JB Weld some new OEM Honda bearings in. Figure if I'm going to end up trashing the hub it is worth a try. My thoughts are the OEM bearings could last a long time based on the type usage it sees..... Rick [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
97 CR80 Rear Hub Worn - Suggestions?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom