Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cleaning/flushing bottom end
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="whyzee, post: 248364, member: 27186"] I’m in the same position. What I did was use carb cleaner and my air compressor. I had the entire clutch assembly out and sprayed everything spotless, then blew it all dry at low pressure. Don’t use a compressor unless you have a moisture regulator, and don’t blow against the gaskets. I was flushing the motor looking for two micro bearings from the throw out bearing, (4 were still in the basket); I later screened the oil and found them. After cleaning, I sprayed everything down with fresh 10w40 oil. Good luck, Dave [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cleaning/flushing bottom end
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom