Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cleaning/flushing bottom end
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="jmics19067, post: 249924, member: 27963"] what I have done by carelessly letting base gasket material fall into the cank area is clean what you see the best you can with rangs in a scooping out kind of motion spray wd 40 gently into the holes of the case over top of the main bearings while rotating crank carefull tunr the whole engine upside down heading towrds the front letting what you have already sprayed into it drain keep it upside down spraying and spinning the crank until you beleive its clean do not use anything like brake cleaner or anything that will ataack the rubber of your seals wd 40 is pushing it in itself when you believ its clean right it back up and dribble some two stroke oil down them holes while spinning the crank and make you sure when you fire it up that its outside and away from neighbors becaseu it is gonna smoke like anything for a bit [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cleaning/flushing bottom end
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom