Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Crank Rebuild
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="_JOE_, post: 1216429, member: 77507"] So the rm250 I sold to my friend this spring is beginning to make a slight growling noise in the bottom end and is starting to smoke a bit more than it used to, so we are going to do crank bearings and seals. It has at least 80 hours on the crank. We did an EG 265 on it about 60 hours ago and it already has a Hot Rod in it. I was wondering if we can just replace the rod when we do the crank bearings and lower end inspection, or if it will need an entire crank. I have never replaced a rod before, but he does have the factory service manual I gave him with the bike. Also anything else to watch for while doing this? Thanks for any advice. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Crank Rebuild
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom