Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Getting Twin Chambers apart!
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="mconnell, post: 629354, member: 37201"] mop - you have a good point on getting out the seals first but I don't think this is the cure. As I was struggling to the forks apart, I noticed I was moving the seal a little bit each time I tried to slide-hammer them apart. Once I had them out about 1/8", I used a spring puller and slid it under the seal lip and pulled the seal out. But, even with the seal and washer out, further difficult slide-hammering was necessary to get the bushings out. Like you said, I did bend the washers into a cone shape, so that proves the seal was tight. I like the idea of the hot water. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Getting Twin Chambers apart!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom