Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
rod play? how much is ok?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Sickboy, post: 1255988, member: 23148"] Hi I have a 2001 CR250, and I've torn it down to where the engine is out of the bike and I'm going to try replacing the crank seals. The bike was running great when I took it apart aside from seriously smoking like crazy all the time, and losing oil from the transmission. Top end looked fine, a little wear but I could see the hone marks everywhere on the cylinder yet. No problems with the bottom end except a suspect crank seal. My question is if my rod bearing is ok... I have a little side to side movement, but pretty small... I don't have the specs yet but I will get a feeler gauge and measure it. There is no up and down play at all, however, when gripping the top of the rod and moving it side to side there is significant play, in other words it can rock side to side on the crank. Is this a big deal ? What type of bearing is the rod bearing? [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
rod play? how much is ok?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom