Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Tech help - KDX 200 cylinder Boring
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="omrik88, post: 1421624, member: 116035"] Thanks for the help guys! * Julien_d , i have an experience with another cylinder which was sleeved and had a bad porting job done to it. It has alot of power, but it never works clean, and is very hard to idle/tune/jet. I prefer going with boring and plating, and no sleeving. But i still don't know how much "material" i can remove in diameter from the bore? Does anyone know what is the Tolerance for this? before having to use a sleeve! *About pistons-in Wiseco website for example,for year 86-88, they make them in sizes up to 68mm. But they say that any oversize piston requires sleeving. Is this a Must? or just they're opinion? Thanks [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Tech help - KDX 200 cylinder Boring
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom