Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
WR20Z starting issue
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Presto, post: 1427569, member: 123852"] Hey guys, new to the forum, but found it whilst searching for a solution to my WR250Z starting problem. This bike has been has been very reliable up until two weeks ago. Went around a very wet enduro track no dramas, always starts first second kick, then bike stopped dead second lap into MX track. Now all I get is the odd backfire when kicking. I have spark (albeit weak), new spark plug, fresh fuel, and stator coil resistance although higher than spec, is intact. All other electrics appear ok. This leaves me to another dicovery, the rubber gromet was out of place on the rotor cover, where the wires run into the stator unit, now I dont know if this has allowed water to enter the stator coils damaging them in some way, but resistance apperas ok. This can only point to a crook CDI unit??? Experience thoughts would be appreciated. I am a sparky by trade, and by no means mechanical, very much a read and fix type of bloke. All comments welcome. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
WR20Z starting issue
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom