250MODROD

Member
Apr 10, 2007
3
0
I am in need of torque specs for 02 rm 250 cylinder and head. plus I would like some advice on fuel octane and mix ratio for break-in period. Also I have heard a few different ways to break the motor in. I have heard to get the bike started and let it idle for 10-15mins. to get the rings seated. Then let cool completly re-torque jug and head bolts and then for the first two tanks not to hold the throttle open for longer than 3 second intervals....is this good bad suggestions and comments appreciated!
THanks all,
Nathan
 
Top Bottom