Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
03 CR250 motor mods, Eric Gorr 10/21/02
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Jman271, post: 473248, member: 25310"] I didn't notice any epoxy, but he could have done it, and then ground it down to a smoother finish, like what is stock inside the port window. In other words, if he did epoxy, I couldn't tell where the blend was. The stock motor had no low end, this big climb through the mid w/a short burst of power near the mid-top, then it goes to the top end, falls off the pipe and the power goes away. There was some good power in there, just a very small window to harness it as usable. It was kinda hard to ride. EG mods def helped it everywhere. I am new to the port timing thnig as well, but I am learing very quickly. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
03 CR250 motor mods, Eric Gorr 10/21/02
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom