03 CRF 450 Basket case Please Help

PAB670

Member
Jul 21, 2004
4
0
My buddies 450 stumbles and sputters at 1/4-1/2 throttle not sure why, We have taken parts off of my bike and tried them on his and still no change Here is a list of what we have done

changed CDI,TPS,COIL,STATOR, PICK UP COIL, SPARK PLUG, AIR FILTER ,FUEL
NEW INTAKE VALVES 2 WEEKS AGO and we did a leak down test. Als checked the head pipe for cracks its ok. I put his carb on my bike it ran fine we have checked all the wiring connections they look good. The bike runs ok when cold after doing 5 laps on the track it starts to act up and just gets to the point were you can't ride it safely. It runs fine wide open let off and try to accelerate and it stumbles mid range is awful tried riding it at half throttle and it skips badly. Any ideas?
Thanks for any help

The only thing's we have not done is change out the fly wheel and put my carb on his bike

--------------------
MOTOCROSS== No Time outs, No pit stops. That's what other sports are for

:bang: :bang:
 
Last edited:

Ol'89r

LIFETIME SPONSOR
Jan 27, 2000
6,961
45
 

PAB670

Member
Jul 21, 2004
4
0
:bang: i tried the pick up coil when we did the stator. Thanks for the help :bang:
 
Last edited:

turboandy

Member
Jan 3, 2003
82
0
You are fat, the fact that your motor is only acting up at 1/4 -1/2 throttle openings tells you it is in the carb. Ignition is not going to act up only at specific carb openings but rpms. I agree about the ignition heating up but your problem is going to be in the carb. The other strong indication is when it is cold it is ok. A cold motor likes to be richer than a warm motor. Check the carb and clean it. If you are mistaken and the engine is not only acting up at 1/4-1/2 but only when hot check the valve and decompression clearance then ignition. ;)
 

Ol'89r

LIFETIME SPONSOR
Jan 27, 2000
6,961
45
 

a454elk

Mexicutioner
LIFETIME SPONSOR
Jun 5, 2001
7,538
18
I can attest to the hot start button problem, makes it extremely tough to keep at a decent idle as well.
 

Ol'89r

LIFETIME SPONSOR
Jan 27, 2000
6,961
45
turboandy said:
hey Old89, I did not mean to insult you, if I did I am sorry we cool ?

:ohmy: Andy. Just foolin' with ya buddy. ;)

It's pretty hard to insult me. Elk's been trying for years now and it just aint happening. :rotfl:
 

PAB670

Member
Jul 21, 2004
4
0
Case Solved

Ok case solved we replaced the the needle and nozzle and the floating side of the slide. BIKE RUNS GREAT I also found that the top cover was not sealing due to the locating tabs were to long so dirt was getting sucked into the carb. So I filed down the tabs and it seals mint.. Again Thanks For all the help....
:yeehaw:
--------------------
MOTOCROSS== No Time outs, No pit stops. That's what other sports are for
 
Last edited:
Cookies are required to use this site. You must accept them to continue using the site. Learn more…