I have an 03 YZ250, and just installed the Race Tech valves in the forks today. I'm not sure if I need to remove the mid valve or not- is it a bad idea? I'm 175lb intermediate and the stock forks seemed to bottom no matter the oil level or clicker settings. I got the Gold Valves to learn how to do it myself, and it was not that difficult. Are the shim recommendations from Race Tech pretty close?Originally posted by marcusgunby
bad valving IMO on all modern YZs.
Originally posted by Big Daddy
03 YZ250 Forks
I have a 03 YZ250. I think the midstroke of the forks are harsher than my old 98 cr125 with .42K springs. I have read this issue in the mags, but is there a cheap fix for this. I'm not in to revalving or sending my forks away. Lower the oil and install heaver springs or opposite? Any one read a fix for this? I do bleed the forks after every ride. Stock settings.
6' 190lbs.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?