I have a factory manual for my bike...
I reassembled my bike after changing the crank pin and bearings. It was done at a shop on a jig and balanced.
After getting the covers on, I tried to turn my engine with the kickstart lever. It turned nicely, but the lever never "bottomed" out. It goes all the way to the foot peg now. What did I miss? Did I forget to do something?
Some facts, I didn't dissassemble the starter mechanism. I only pulled it out of the engine case. I am unsure of the spring tension and orientation.
Any advice would be nice.
thanks, Charger71
I reassembled my bike after changing the crank pin and bearings. It was done at a shop on a jig and balanced.
After getting the covers on, I tried to turn my engine with the kickstart lever. It turned nicely, but the lever never "bottomed" out. It goes all the way to the foot peg now. What did I miss? Did I forget to do something?
Some facts, I didn't dissassemble the starter mechanism. I only pulled it out of the engine case. I am unsure of the spring tension and orientation.
Any advice would be nice.
thanks, Charger71