1994 KDX 250 Piston

[ThysW]

Does anyone have the part no. for a 1994 KDX 250 SR two stroke

 

[mudpack]

I can have it for you tomorrow, when I go back to work.
There may be more than one piston/part number.

Mud

 

[julien_d]

this should be the wiseco part number for standard bore, 91-97 KDX250

607M06740

I am not sure if the SR uses a different part though.....

 

[mudpack]

The Kawasaki part number for the 1994 KDX250 D4 (US model) is 13001-1345. There is only one listed.

 

[ThysW]

I sent my barrel and old piston to ns two stroke so they can renikkel the barrel and supply me with a new piston. They redone the barrel and supplied me with a piston, but the piston sticks out about 5mm above the barrel. Can it be that they give me a KDX 200 piston. And yes they thew the old one away before I picked up there are a mistake.

 

[mudpack]

I sent my barrel and old piston to ns two stroke so they can renikkel the barrel and supply me with a new piston. They redone the barrel and supplied me with a piston, but the piston sticks out about 5mm above the barrel. Can it be that they give me a KDX 200 piston. And yes they thew the old one away before I picked up there are a mistake.

Probably not. A 200 piston would have a LOT of clearance.
Take it back...the whole engine...and show them the problem.

 

[ThysW]

They are about 1000Km away from me, when I told them about the problem they said I must buy a conrod kit. But if they cant even supply me with a correct piston, I realy doubt it if they will supply me with the correct conrod kit and gaskets.

 

[Tom68]

Gaskets from Kawasaki, KX250 125mm conrod. You should have got the factory piston, nobody makes a replacement.