changing the springs.
Well, I did mine without taking the forks out...that would seem like alot of work! A quick run down is I put the bike up on a 5 gallon pucket, loosened the top triple clamp bolts, Loosen the big nut/cap on the top of the forks-all the way off, pull the front tire up to the fender to push the springs up. Then, grap a couple sizes of open end wrenches, around 1/2" or so, and you can use one to hold down the spring and spacer while you lossen the cap off of the rod. Once you have the cap off of the rod, twist a 2' piece of small rubber hose on there, like the house that goes from your petcock to your carb. The rod will want to fall into the fork tube, put you will be able to pull it back out, or just hold it up with the rubber tube, while you take the old spring out and put the new spring in. After that, its all just reverse of taking it apart, and then do the other side. Hope you can make some sense of this!
Troy