Reply to thread

Message: [QUOTE="Badbowtie73, post: 1358803, member: 108812"] Ok i think I will go ahead and take it back apart and soak it. I will take the floats off and see if those might be sinking. I have read that you need to set the floats by measuring from the bottom of the float to the gasket surface, i have also seen where you need to measure from the casting line in the float to the gasket surface. i have done it both ways and it runs the same either way. Which one is the correct method? Thank you guys for your advice. Sometimes i overlook the obvious stuff. I once almost started tearing into the motor on my CR because it was running like crap and luckily i realized the choke was still on :laugh: [/QUOTE]