Reply to thread

Message: [QUOTE="jtimpano108, post: 1467916, member: 140995"] Sorry for the late reply but here’s where I’m at...I tore the engine back apart after noticing the power valves weren’t doing anything I took them out and cleaned them off now they are like new I took apart the bottom end cover on the clutch side and noticed the push rod wasn’t even connected got the clip for it and connected it out everything back together started the bike and watched the power valves open and close as I rev the bike it’s actually running a lot better but it doesn’t have any balls to it can’t even get it to lift the front tire every time the bike runs and I shut it off the carb starts dumping fuel out of the over flow after I checked the carb I saw that it has a 180 main and a 55 pilot when I called and asked for recommended jetting for my exhaust they said 170 main and a 50 pilot 1.5 turn of the air screw so I ordered the new jets once they come in I’m going to rebuild the carb check the float needle and float height and also ordered a new air filter after all of this I’m hoping the bike is going to have the kick it’s suppose to. Would these much bigger jets that are in it flood the bike enough to make it have horrible power output?? Thanks for the input [/QUOTE]