Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
99 exc 200
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="KTM-Lew, post: 542410, member: 28038"] If the spacer is 57mm long that doesn't give you 57mm pre-load. Is that what you measured? You must measure from the spring to the cap.....Leave the pre-load spacers out and install the cap into the tube.....then pull the tube up and measure from the seal/dust cover to the top....push the tube down until you feel the spring touch the cap....measure again. Now you have the length the spacer needs to be to have 0 pre-load. Compare this measurement to the old spacer. You will probably have to get the springs tested as mentioned above. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
99 exc 200
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom