Reply to thread

Message: [QUOTE="shockdoc, post: 83955, member: 23028"] KXVET is right on the money with his set-up procedure. The only thing I personally would do different is after the axle & L/S pinch bolts have been tightened fully I take a small straight blade screwdriver and wedge it in the gap between R/S pinch bolts. Since the hole on the fork leg is slightly smaller than the axle this will let the fork "float" on the axle and you can take and feel that the fork is not bound up. If you push & pull on the bottom of the leg it will find its position. A lot of people hammer on the end of the axle to drive it in so this will burr the end. I always make sure axle is deburred and will slide through the holder smoothly before installing axle. doc [/QUOTE]