Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
and so the saga continues............ PWK carb!
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="jmics19067, post: 663109, member: 27963"] Bruce, what do you mean by an irreversible mod? did you have to cut the rubber stuffers off the stock manifold? If so it might be worth it to just go out and buy a new rubber manifold and start from scratch. It MIGHT be worth it to get a decent baseline of carb settings with a stock intake just to get a good feel of how the bike should act , it could get you closer to bringing the vforce in check. very easy for me to gamble though when it isn't my money but too me 50$ or so at this point would be minimal to the amount of aspirin eaten let alone needles and slide mods. I was also wondering about your mikuni setup. If I remember correctly you end milled where the needle sets in the slide and then had to shorten the needle length. Could using a 36mm tmx needle open up your options a little more for your mikuni problems? So you wont have to fit the length as you did. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
and so the saga continues............ PWK carb!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom