Reply to thread

Message: [QUOTE="canyncarvr, post: 523832, member: 16552"] An input from the simple minded side... I'm sure the 'correct way' is ....well...correct and all. I fail to see the purpose of it all though. Why not 'just' adjust the tang so the mold line of the float is 'about' 1mm under parallel when the tang 'just' touches the float needle pin? Takes you a couple of minutes. No fuel used at all. It works. No deleterious consequences. ...simple....... BTW...bending the tang [b]DOWN[/b] is the wrong direction if you want to lower the fuel level in the bowl. Bending it down will allow the floats to go higher before the fuel is shut off at the needle. ..assuming you aren't looking at the carb upside down....;) [/QUOTE]